1010
Operating Instructions
The illustration below shows the remote controller display. What is actually displayed depends
on how the water heater is set.
Time Display
When the hot water tem-
perature is set between
60~80°C, “hi-temp” blinks
for 10 seconds.
High Temperature Display
(Eg.: 40°C)
Selection switches that can
be operated are indicated
by the bar display lighting
up or blinking.
Selection Bar Display
Temperature Setting
This is displayed during
burner on.
Burner On Display
< Scroll display > to prevent the remote controller screen from burning out
( This page)
(Eg.: 10:15)
Names and Functions of Controllers
Main Remote Controller (RCM3211) <
Optional>
Error Display
Error is displayed when
malfunction occurs.
( P35)
Display
Set Button
For other settings.
Speaker
Power On/Off Button
For turning the heater on
and off.
Selection Button
• Used to adjust the
temperature. ( P14)
• Used for other settings.
• Details are memorized
upon adjustment or setting.
Display
·
In order to prevent the screen burning out, about 10 minutes
after any remote control operation, the screen display begins
to scroll sideways.
·
As soon as the remote controller is used again, the scrolling
stops.
Current time (when the clock
is set) and hot water tempera-
ture scroll sideways.
To Next Page
Loading...
