1717
Operating Instructions
On this Display Operation Description
Press the
ON/OFF
button to turn it
“On”.
Press the
SET
button to change the
display until “time
set” is shown.
1
2
Use the
buttons
to adjust the clock.
3
< Completion of setting >
* When the
SET
button is pressed,
or the console is left untouched for
about 20 seconds, the settings
screen ends.
* The
ON/OFF
is lit.
* The time changes in 1-minute
increments with each press on the
button, and then in 10-minute
increments if the button is kept
pressed down.
Clock Adjustment
(Eg.: 40°C)
(Eg.: AM 10:15)
In the event of a power cut or after disconnecting the power supply, when the power is
restored, the clock on the display screen shows “0:00”, so the clock needs to be re-set.
When using RCM3211
To Next Page
Loading...
