13
If you have an electric system
Select Electric and click Next Arrow at the top right
corner of the screen
If you have no heating appliance
Select No Heating and click Next Arrow at the top right
corner of the screen
Select your stage configuration
Select your stage configuration according to the heating
and cooling appliances you have in your home and
then click Next Arrow at the top right corner of the screen.
4. Use the Balance Point to set the outdoor temperature value the
thermostat will use to switch between your heat pump and fossil
fuel appliance. Above this value, your thermostat will use your
heat pump to heat your home and below this value, your
thermostat will use your fossil fuel heating appliance.
5. Use the Change over Delay to set the time the system will be off
when changing between heat pump and fossil fuel heating
sources. This delay allows for the coil to cool before switching
between heating appliances.
Note: In a dual fuel system, the BCC110 automatically enables
auxiliary heating using the fossil fuel heating appliance.
Note: In a dual fuel system, the BCC110 will stage up from heat
pump to fossil fuel following the stage settings, which can be
modified in Advanced Settings > Installer Access > by using the
ST Action Code.
6. Click Next Arrow at the top right corner of the screen.
If you have a whole home humidifier or dehumidifier
accessory wired to your thermostat, select the type of
accessory you have in your home; otherwise, click None
and then click Next Arrow.
Note: Professional installation is recommended for humidifiers
and dehumidifiers.
If you have a Humidifier
1. Select Humidifier and click the Next Arrow at the top right
corner of the screen.
2. Then select Evaporative or Steam following the on-screen
instructions. For Evaporative the humidifier is activated only
during active heating. For Steam the humidifier is activated
regardless of a heating call.
3. Click Next Arrow at the top right corner of the screen.
If you have a Dehumidifier
1. Select Dehumidifier and click the Next Arrow at the top right
corner of the screen.
2. Then enable or disable Cool to Dehumidify following the
on-screen instructions. If Cool to Dehumidify is enabled the
dehumidifier is activated only during active cooling. If disabled
the dehumidifier is activated regardless of a cooling call.
3. Click Next Arrow at the top right corner of the screen.
Need Help?
If you are unsure of which option to select,
contact your local contractor or our
support line: 1-800-283-3787.
To Next Page
Loading...
