Bosch Bulls Aminga E1 - Gear Recommendation; Tachometer Screen; Function Display

MY20B01-32_1.0_21.06.2019
34
Overview
System data
To view all the information on the system being
used and the software, the rider has to call up the
system data.
System message
The drive system monitors itself continuously and
if an error is detected, it is indicated by a system
message. The system may switch off
automatically depending on the type of error.
There is a table of system messages in the
appendix
Figure 23: The left battery is currently being charged
3.6.3.4 Gear recommendation
Pedalling frequencies higher than 50 revolutions
per minute optimise drive unit efficiency.
However, very slow pedalling uses up a great deal
of energy. You can increase the speed and range
while applying the same force by selecting the
right gear. It is therefore best to follow gear
recommendations.
The gear recommendation function reacts to
excessively slow or excessively quick pedalling
and recommends a change of gear.
 The gear recommendation function has to be
switched on in the system settings.
3.6.3.5 Tachometer screen
The tachometer shows the current speed at all
times.
You can select whether the speed is displayed in
kilometres or miles in the system settings.
3.6.3.6 Function display
The function display shows texts and readings.
Three different types of information are shown:
• Journey information
• System settings and data, and
• System messages.
Journey information
Depending on the type of pedelec, the function
display may show up to seven journey information
items. The displayed journey information can be
switched.
Additional journey information
Applies only to Pedelecs with eShift with
Shimano DI2 automatic hub gears
The following additional functions are available on
the function display:
Screen display Function
SEARIAL NUMBER DU Drive system serial number
SEARIAL NUMBER HMI Serial number for control panel
with display
SW VE RSION H MI Software version of the control
panel with display
SW VERSION DU Drive system software version
SW VERSION PP Battery software version
Table 34: System data, not changeable
OF
MP
H
KM
/
Symbol Use

Pedalling frequency is too high, a higher gear is
recommended

Pedalling frequency is too low, a lower gear is
recommended
Table 35: Symbols of the gear recommendation function
Screen display Function
CL OCK Current time
MAX. SPEED Maximum speed reached since the
last RESET
AVG. SPEED Average speed reached since the last
RESET
TRIP TI ME Journey time since last RESET
RA NGE Estimated range of the available
battery charge
ODOME TER Display of the total distance travelled
(cannot be changed)
TRIP DISTANC E Distance travelled since the last
RESET
Table 36: Journey information
Screen display Change
AUTO: ON/A UT O: OF F This menu option indicates
whether the automatic mode is
switched on or off
.
Table 37: Additional journey information