EasyManua.ls Logo

Bosch Bulls Aminga E1 - Overview of Actions; Switching on the Display; Switching off the Display; Using the Push Assist System

Bosch Bulls Aminga E1
119 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MY20B01-32_1.0_21.06.2019
76
Operation
6.11.3 Overview of actions
6.11.4 Switching on the display
Press the On-Off button (display) once.
The electric drive system is switched on.
6.11.5 Switching off the display
If the display is not inserted into the mount, it will
switch off automatically after one minute to save
energy if no button is pressed.
Press the On-Off button (display) once.
The electric drive system is switched off.
6.12 Using the push assist system
The push assist helps the rider to push the
pedelec. The speed can be a maximum of 6 km/h
in this case.
The tractive power of the push assist and its
speed can be influenced by the selection of gear.
To spare the drive, first gear is recommended for
travelling uphill.
The level of assistance OFF must not be
selected.
Press the push assist button to activate the
push assist.
Press and hold the plus button within 3 seconds
to switch on the push assist.
Release the plus button to shut off the push
assist. The push assist system switches off
automatically as soon as the pedelec wheels
are blocked or the speed exceeds 6 km.
Action Button Duration
Switching on the display Any
Switching off the display Any
Activate push assist
Use push assist
WALK
+
1. < 1 second
2. Any
Switch on bicycle lighting
+
1–2.5 seconds
Switch off bicycle lighting + > 2.5 seconds
Increase assistance + < 1 second
Reduce assistance < 1 second
TRIP/TOTAL/RANGE
screen, assistance modes
1–2.5 seconds
Reset journey distance – + > 2.5 seconds
Switch from kilometres to
miles
1. Hold
2. < 1 second
Get versions + 1. Hold
2. < 1 second
Set display brightness + 1. Hold
2. < 1 second
Table 56: Overview of actions
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the pedelec wheels are not in contact with
the ground when the push assist system is used
(e.g. when carrying the pedelec up stairs or when
placing it on a bicycle rack).
Only use the push assist mode when pushing
the pedelec.
You must steer the pedelec securely with both
hands when using push assist.
Allow for enough freedom of movement for the
pedals.
Notice
The push assist cannot be activated at the OFF
assistance level.
CAUTION
!

Table of Contents

Related product manuals