Need help?Do you have a question about the Bosch CDL2-15H and is the answer not in the manual?
General| Coverage | 360° |
|---|---|
| Type | Motion Detector |
| Detection Technology | Passive Infrared (PIR) and Microwave |
| Detection Range | 15 meters |
| Alarm Contact | Normally Closed (NC) |
| Housing Material | Plastic |
Advises on bracket use, catch performance, and regulatory certification.
Explains the operation of the self-locking cam for opening and closing the detector.
Describes options for installing the detector using the base or brackets.
Overview of the TriTech AM terminal block and its connections.
Overview of the TriTech terminal block and its connections.
Details requirements for connecting power to the detector.
Explains the normally closed relay contacts for alarm signals.
Explains the tamper switch functionality.
Explains the normally closed relay contacts for trouble signals.
Introduces the use of built-in resistors for loop wiring.
Details using dip switches for alarm resistor configuration.
Explains ON/OFF switches for single/dual EOL resistor configuration in TriTech AM.
Details using dip switches for tamper/EOL resistor configuration.
Discusses combinations of EOL resistors for loop wiring.
Illustrates wiring for single EOL loop with alarm and tamper for TriTech.
Illustrates wiring for single EOL loop with alarm and tamper for TriTech AM.
Illustrates wiring for double EOL loop with alarm and tamper for TriTech.
Illustrates wiring for double EOL loop with alarm and tamper for TriTech AM.
Illustrates wiring for double EOL loop with alarm, tamper, and trouble for TriTech.
Steps for performing a walk test to check and adjust detector coverage.
To Next Page