Bosch Climate 5000i M Series - Operation

Product Information
51
Climate 5000iM – 6721849823 (2022/11)
2Product Information
2.1 Declaration of conformity
The design and operating characteristics of this product comply with the
European and national requirements.
The CE marking declares that the product complies with all the
applicable EU legislation, which is stipulated by attaching this
marking.
The complete text of the Declaration of Conformity is available on the
Internet: www.bosch-industrial.com.
2.2 Technical data wired room controller
Table 2 Technical data wired room controller
2.3 Specifications of remote control
Table 3 Specifications of remote control
2.4 Operating temperature range
Table 4
The built-in protection device may prevent the appliance from operating
at temperatures outside the above range.
If the humidity is more 80 %, condensation may form at the air
outlet. To avoid this, set the fan to a high performance.
3Operation
3.1 Indoor unit overview
Key to Fig. 1:
[1] Air inlet
[2] Electric control box
[3] Air filter
[4] Air Outlet
3.2 Indoor unit display
Key to Fig. 2:
[1] Manual operation
[2] Status indicator
[3] Timer indicator
[4] Pre-heating and defrosting indicator
[5] Alarm indicator
[6] Infrared signal receiver
[7] LED indicator
The operating modes can be selected in the sequence automatic mode,
cooling mode and shutdown via the Manual operation key.
Manual button
Table 5 Indications on the display unit
3.3 Overview wired room controllers
Keys of the wired room controller
Key to figure 3:
[1] Receiver for infrared remote control
[2] Display of the wired room controller
[3] Keys of the wired room controller
Table 6 Keys of the wired room controller
Power infeed DC 12V
Permissible ambient temperature −5 °C... 43 °C
Permissible relative humidity 40...90 %
Power infeed 2 AAA batteries
Signal range 8 m
Permissible ambient temperature 16... 30 °C
Room temperature Outside temperature
Cooling 16 ... 32 °C -15... 50 °C
Heating 0 ... 30 °C -15... 24 °C
Dehumidifying 10... 32 °C 0... 50 °C
Operating
Mode
Display Display output
Automatic
mode
Operation indicator
on
Cooling and heating modes:
Set temperature
Fan only mode: Indoor ambient
temperature
Manual cooling
mode
Status indicator
flashes
The system automatically
switches to automatic mode after
30 minutes of forced cooling.
The remote control is deactivated
during forced cooling.
Shutting-down All indicators off If the display is switched off, the
indoor unit switches off and the
remote control is reactivated.
Key Function
K Switch on/off.
M Set operating mode.
DAYOFF Day off/deletion.
. / Adjust up/down setting.
 Confirm choice.
TIMER Set timer.
Fan step
d Navigate back.
No function.
FUNC. Set function.
COPY Copy/adopt data.