EasyManua.ls Logo

Bosch Climate 5000i M Series - Maintenance; When Re-commissioning After Decommissioning for an Extended Period

Bosch Climate 5000i M Series
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
55
Climate 5000iM – 6721849823 (2022/11)
4 Maintenance
CAUTION
Danger due to electric shock or moving parts
Disconnect the power supply before carrying out any maintenance
work.
Have any maintenance steps that are not listed here carried out by an
approved installer.
4.1 Replacing the batteries
You require 2 size AAA batteries. Using rechargeable batteries is not
recommended.
Remove the battery cover ( Fig. 7).
Insert new batteries, ensuring correct polarity.
Reinstall the cover.
4.2 Cleaning
NOTICE
Damage to device due to incorrect cleaning!
Do not directly splash or pour water onto them.
Do not use hot water, thinner, abrasive powders or strong solvents.
Clean control unit by wiping with a soft cloth.
Only have the indoor and outdoor units cleaned or serviced by an
approved installer.
4.3 Cleaning the air filter
NOTICE
The air filter may deform in direct sunlight.
Do not expose the air filter to direct sunlight.
Check the air filter every 2 weeks and clean if necessary. Always clean
before and after decommissioning for longer periods.
Switch off the indoor unit.
Pull out the air filter ( Fig. 8).
Wash the air filter with hot water and a mild cleaning agent and dry in
the shade.
4.4 When re-commissioning after decommissioning for
an extended period
4.4.1 Maintenance before decommissioning for an extended
period:
Clean the air filter of the indoor unit.
Leave the fan of the indoor unit running for approx. 24 h in Fan Mode
to allow the inside of the appliance to dry.
Switch off the indoor unit and disconnect it from the power supply.
Protect the devices from dust.
Check the outdoor unit at regular intervals. Contact customer service
or an authorised service engineer if a fault occurs.
4.4.2 Maintenance after a long period of non -use
Wipe the air inlet grille with a clean dry cloth so the indoor unit does
not blow out dust.
Make sure that the air inlet and air outlet are unobstructed and have
not been inadvertently adjusted.
Check all cables and connect the power supply.
If required, make sure that the air filter is installed.

Related product manuals