Conettix DX4020 | Installation Guide | 6.0 IP Address Programming
.
Bosch Security Systems, Inc. | 1/09 | F01U045288-05 13
17. Press [Enter] after entering the correct number of
bits for the Netmask.
Table 5: Netmask Addresses
Host Bits Netmask Host Bits Netmask
1 255.255.255.254 17 255.254.0.0
2 255.255.255.252 18 255.252.0.0
3 255.255.255.248 19 255.248.0.0
4 255.255.255.240 20 255.240.0.0
5 255.255.255.224 21 255.224.0.0
6 255.255.255.192 22 255.192.0.0
7 255.255.255.128 23 255.128.0.0
8 255.255.255.0 24 255.0.0.0
9 255.255.254.0 25 254.0.0.0
10 255.255.252.0 26 252.0.0.0
11 255.255.248.0 27 248.0.0.0
12 255.255.240.0 28 240.0.0.0
13 255.255.224.0 29 224.0.0.0
14 255.255.192.0 30 192.0.0.0
15 255.255.128.0 31 128.0.0.0
16 255.255.0.0
When using DHCP, the following message
appears:
To assign a device name for use on a LAN,
type Y, enter up to 16 characters, and press
[Enter]. Otherwise, only press [Enter].
When using the DX4020 to communicate
to RPS over a network, enter a unique name
known to the person programming the
control panel.
If you do not enter a DHCP device name,
the default Cxxxxxx is used (where xxxxxx is
the last six digits of the MAC address).
18. Change the Telnet password by pressing [Y] and
entering a password or press [Enter] to leave the
default telnet password.
This screen shows the Setup Mode screen you
previously saw.
Keep your password in a secure place. If
you forget or lose the password, you cannot
use Telnet again to configure the DX4020
until the DX4020 is returned to the factory
for reconditioning.
19. Press [1] and [Enter] to access the setup Channel 1
configuration.
20. Press [Enter] to accept 9600 as the default baud
rate. If 9600 is not the default, type 9600 and press
[Enter] to change it.
21. Press [Enter] to accept 4C as the default I/F Mode.
If 4C is not the default, type 4c and press [Enter] to
change it.
22. Press [Enter] to accept 00 as the default flow. If 00
is not the default, type 00 and press [Enter] to
change it.
23. Type a unique port number for the LAN the
device is connected to and press [Enter].
To Next Page
Loading...
