Operation
Climate Room Control – 6721841498 (2022/04)
64
The ON/OFF timer cannot be set at a secondary wired room
controller.
5.5.2 Weekly ON/OFF timer
Setting timer
▶ Press the TIMER key until WEEK 1 appears in the display.
▶Confirm with key.
▶ Press the . or / key to select the weekday.
▶Confirm with key.
▶ Press the . or / key to set the desired ON time.
▶Confirm with key.
▶ Press the . or / key to set the desired OFF time.
▶Confirm with key.
Up to four times can be set.
▶ Repeat procedure every subsequent day of the week.
To delete the timer for the selected day:
▶ Press the DAY OFF key.
Activating the timer
▶ Keep pressing the TIMER key until WEEK 1 appears in the
display.
The timer is now switched on. The unit is switched on or off
at the selected times and days.
Deactivating the timer
▶ Keep pressing the TIMER key until WEEK 1 disappears in
the display.
To switch off the unit when the week timer is active:
▶Briefly press K key.
The unit switches off until the next ON timer is reached.
▶Hold the K key pressed for two seconds to switch off the
unit and deactivate the week timer.
Programming the switch-on delay
If week timer 1 is active and the ON time is to be delayed.
▶ Select week timer 1 with TIMER key.
▶ Press the DAY OFF key 2x until 1h appears on the display.
▶ Wait for a few seconds while the setting is saved.
The unit now starts the next activity cycle following a delay
of 1 hour.
▶ Press the DAY OFF key 3x until 2h appears on the display.
The unit now starts the next activity cycle following a delay
of 2 hours.
5.5.3 Weekly event timer
Setting timer
Up to 8 events can be set for each day to change the operating
mode, temperature and fan speed.
▶ Keep pressing the TIMER key until WEEK 2 appears in the
display.
▶Confirm with key.
▶Press the . or / key to select the weekday.
▶Confirm with key.
▶Press the . or / key to select the setting time, main
operating mode, temperature or fan speed for the event.
▶Confirm with key.
▶ Make the setting and press the key to confirm or the
DAY OFF key to delete the setting.
▶ Repeat the procedure to define additional setting periods
for this day.
▶ Follow the same procedure to program additional
weekdays.
To delete the timer for the selected day:
▶Press the DAY OFF key.
Defining the setting time
▶Press the . or / key to adjust the time.
▶Confirm with key.
Selecting the main operating mode
▶Press the . or / key to select the main operating mode
( Table 29, [1], page 62) ).
▶Confirm with key.
The fan speed cannot be adjusted in automatic and
dehumidification mode.
Setting the room temperature
▶Press th . or / key to set the desired room temperature.
▶Confirm with key.
Fan step
▶Press the . or / key to adjust the fan step.
▶Confirm with key.
The temperature cannot be adjusted in Fan Mode.
To Next Page
Loading...
Need help?
General
