Fire System | User’s Guide | 13.0 Log Event Definitions
Bosch Security Systems, Inc. | 8/06 | F01U011793B 38
13.0 Log Event Definitions
Table 6: Log Event Definitions
Text Definition
AC FAIL
AC power to the control panel is interrupted
AC RSTOR
AC power to the control panel is restored.
ALARM
Alarm at point in specified area.
AUTO
Event modifier for BYPASS event. Indicates four
alarms or troubles in one clock hour caused
automatic (swinger) bypass.
BAD CALL
System tried to call Remote Programming
Software (RPS) and failed.
BATT LOW
Control panel battery is below 11.7 VDC.
BATT MISS
Control panel battery is disconnected or
discharged.
Table 6: Log Event Definitions (continued)
Text Definition
BATT RSTOR
Control panel battery is recharged.
BUS RSTOR
Data Expansion Loop for off-board points
restored.
BUS TRBLE
Data Expansion Loop for off-board points faulted.
BYPASS
Point is bypassed. An event modifier showing
how the point is bypassed follows this event in
the log.
CANCEL
User canceled an alarm from the area specified.
CKSUM FAIL
Control panel programming is corrupted. Call for
service.
COMM FAIL
Control panel could not communicate using
phone line reported.
COMM RSTOR
The communication problem with the indicated
phone line is resolved.
To Next Page
Loading...
