Bosch D7212GV3 - Other Features; Installation; Installation Preparation; Enclosure Options

D7212GV3 | Operation and Installation Guide | 4.0 Installation
.
Bosch Security Systems, Inc. | 10/10 | F01U143079-03 13
3.3.15 Other Features
The D7212GV3 Control Panel has many
programmable features. Some of the features are
listed below. Complete details on all features are in
the D7212GV3 Program Entry Guide
(P/N: F01U170808).
• Supervision of AC (primary power), battery
(secondary power), Zonex and SDI buses,
central processing unit (CPU), up to three
printers, and two telephone lines
• Automatic System Test Reports
• Remote access for programming, diagnostics,
and log uploads using the remote programming
software (RPS)
• Fire alarm verification
• Programmable alarm output
• Programmable relay output using the D8129
OctoRelay Module
• Opening and closing windows
• Skeds (scheduled events)
• Limited local programming available in the
Service Menu
4.0 Installation
4.1 Installation Preparation
This section contains a general installation procedure
and refers to other sections of the document for
detailed instructions.
Review this document and the D7212GV3 Program
Entry Guide (P/N: F01U170808) before beginning the
installation to determine the hardware and wiring
requirements for the features used.
Have the following documentation available when
reading through this guide:
• D7212GV3 Program Record Sheet
(P/N: F01U170810)
• Security System Owner’s Manual
(P/N: 71-06633-000) and GV3 Series Owner’s
Manual Supplement (P/N: F01U143082)
• Installation manual for keypad or annunciator
(D1255 all models, D1255RB, D1256, D1256RB,
D1257, D1257RB, D1260 all models, or D720 all
models)
Before installation, become familiar with RPS or the
Local Programmers menu.
4.2 Enclosure Options
Mount the control panel assembly in any of the Bosch
Security Systems, Inc. enclosures listed:
• D8103 Universal Enclosure (tan)
• D8108A Attack Resistant Enclosure (tan)
Refer to the D7212GV3 Approved Applications
Compliance Guide (P/N: F01U143080) to determine if
the application requires a specific enclosure.
4.3 Mounting Enclosure
1. Run the necessary wiring throughout the
premises.
2. Mount the enclosure in the desired location. Use
all five enclosure mounting holes. Refer to
Figure 2.
3. Pull the wires into the enclosure.
Electromagnetic interference (EMI) can
cause problems on long wire runs.