Bosch D7412GV3 - Table 12: Test Reports

D9412GV3/D7412GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 23
Bosch Security Systems, Inc. | 10/11 | F01U170807-02
Table 12: Test Reports
Report Selections
Report
Description
R# S: Alarm
1
Yes, No Status Alarm
R# S: Trouble
1
Yes, No Status Trouble
R# S:
Supervised
2
Yes, No Status Supervised
R# Status
Report
Yes, No Status
R# S: Open
1
Yes, No Status Open
R# S: Close
1
Yes, No Status Close
R# Test Report Yes, No Test
R# S:
Perimeter Inst
1
Yes, No
Status Perimeter
Instant Arm
R# S:
Perimeter
Delay
1
Yes, No
Status Perimeter
Delay Arm
R# S: Fire
Supv
2
Yes, No
Status Fire
Supervision
R# S: Fire
Alarm
3
Yes, No
Status Fire Alarm
Report
R# S: Fire Trbl
2
Yes, No
Status Fire
Trouble
R# S: Msng
Fire
2
Yes, No
Status Fire
Missing
R# S:
MsngBurgTr
2
Yes, No
Status Burg
Missing Trouble
R# S:
MsngBurgAl
2
Yes, No
Status Burg
Missing Alarm
R# S:
FireSpMsng
2
Yes, No
Status Fire
Supervision
Missing
R# S:
SuperMsng
2
Yes, No
Status Non-fire
Supervision
Missing
R# S:
DrLeftOpen
2
Yes, No
Status Door Left
Open
1
Information about this condition is sent with a Status
Report.
2
Information about this condition is sent as S: Trouble
Event with a Status Report.
3
Information about this condition is sent as S: Alarm
Event with a Status Report.
Diagnostics Reports
Selecting Yes enables sending a report when the
event occurs. If the off-normal state of the events
indicated by footnote 1 in Table 13 on page 24 still
exists, the events report when a Test Report is
enabled and Expanded Test Report is programmed
Yes. Refer to the Test Reports sub-prompt in Section
2.3.8 Communication Attempts on page 18.
Get other manuals https://www.bkmanuals.com