Bosch Dinion User Manual

1 2
3 4
microSDHC Card
M3 Screw
Ø 6 mm
x2
x2
This equipment is only to be connected to
PoE networks without routing to outside plant
“This product is intended to be supplied by a Listed Power Unit marked
“Class 2”, “LPS”, or “Limited Power Source” and output rated 12Vdc, 0.
32A minimum; or 24Vdc, 0.16A minimum.”
tnuoMelbmessasiD
)rewoP( krowteN
x3
RJ45
Ethernet (PoE)
5 mm
(0.2 in)
12 VDC
24 VDC
22AWG
Outer n6.0mm 2 Holes
(FOR PLASTIC ANCHOR)
CABLE
Inner n2.5mm 2 Holes
(M3 TYPE SCREW)
FRONT
0
90
180
270
CUT LINE
CAMERA
OUTLINE
DINION and FLEXIDOME 2000 - Quick Installation Guide
NUC-20012-F2, NUC-20002-F2
FRONT
FRONT
FRONT
Pan
350°
Tilt
55°
Adjust

Bosch Dinion Specifications

General

Series	Dinion
Category	IP Camera
Sensor Type	CMOS
Resolution	Varies by model
Minimum Illumination	0.05 lux
Wide Dynamic Range	Yes
Signal-to-Noise Ratio	>50 dB
Power Supply	12 V DC, PoE
Day/Night Functionality	Yes
Infrared	No

Summary

Disassemble Camera

Mounting the Camera

Network and Power Connection

Ethernet (PoE) and RJ45

Connect the camera using an RJ45 connector for Ethernet and Power over Ethernet (PoE) networks.

DC Power Options

Details power connection via 12 VDC or 24 VDC, specifying minimum current requirements.

Camera Adjustments

Pan Adjustment

Adjust the camera's horizontal pan angle up to 350 degrees for optimal viewing.

Tilt Adjustment

Adjust the camera's vertical tilt angle up to 55 degrees for precise positioning.

Install Bosch Video Client

Software Installation

Install the Bosch Video Client software by running 'Autorun' or 'BVC-installer.exe'.

Initial Setup Wizard

Default IP Address

Configure the camera using the setup wizard, noting the default IP address is 192.168.0.1.