1:10
Electronic Oven &ontrol Operation
When the appliance is first plugged in, or when the power supply to the
appliance has been interrupted, the display will flash .
To set the clock:
1. Press &/2&. once (do not hold pad down).
2. Within 5 seconds, press and hold or until the
desired time of day appears in the display.
Note: The clock cannot be changed during any timed ake
or elf-clean cycle.
2
1
In addition to the ailure/ault odes that are built into the control
ervice ode can be activated to monitor the oven temperature as
reported by the oven sensor to the control. This mode may be useful
when using a thermometer to test oven temperature since it will allow
the technician to monitor the temperature recorded by the thermometer
and compare it to the temperature reported by the sensor probe.
To enter ervice ode unplug or turn off the power to the range.
While holding the C keypad down restore power to the range.
The control will now show the internal oven temperature that is being
reported by the sensor.
PowerUp Display
Service Diagnostic Mode
To exit Service Mode, press the CLEAR/OFF keypad or disconnect
power to the range.
Note: If the oven cavity temperature reaches 500°F, during Self-clean,
the door will remain locked until the oven cools below 500°F.
To Next Page
Loading...
