3:1
When
an error or failure occurs in the ven control odule
the control panel will usually produce an audible beep accompanied by a
special display to indicate that there is a failure condition.
The illustration to the right shows an oven control displaying the F11
error code (Stuck Keypad). To correct the failure condition follow the
troubleshooting steps found in the tech sheet located on the back of the
range.
For each ault code there is a listing of the likely failure condition or cause, as well as suggested corrective actions to be taken. Perform the steps
one at a time LQWKHRUGHUOLVWHG to correct the specific failure condition.
The tech sheet found on the back of each range provides detailed information for checking component circuits and wiring as well as a listing of the
failure/fault codes that may be displayed in the event of a specific failure condition. The following page illustrates an example of the fault code table
as seen on the tech sheet .
Electronic &ontrol 0RGXOHFailure/Fault Codes - ES337
TROUBLESHOOTING
To Next Page
Loading...
