2:2
Oval Burner - 500 Series Ranges
The surface burners on 500 series gas ranges are the same as those on
the 300 series ranges with the exception of the center oval burner shown
in photo A.
This burner has a decorative cap that can be removed but is not a
serviceable item. The cap and burner are replaced as an assembly.
Photo A
Photo B
The oval burner can be lifted off to access the orifice holder and orifice
without removing any screws. Once the burner is removed the orifice
holder and igniter tip are visible. The orifice can be service through the
hole in the orifice holder assembly (hoto B)
To Next Page
Loading...
