Bosch Evolution 300 Series - Bake Burner Igniter

2:14
Bake Burner Orifice
The bake burner orifice hood is on the gas safety valve located beneath
the . To access the orifice remove the storage drawer. Photo A
shows the orifice and safety valve assembly. The bake burner has been
removed for clarity.
The bake burner orifice is pre-set for atural gas but can be adjusted
for LP gas by turning the orifice hood clockwise until it is snug. 
&RQYHUVLRQIURP1DWXUDO*DV1*WR/LTXLILHG3HWUROHXP/3

2YHQ%DNH
%XUQHU

the two screws
indicated in photo A
Photo A
Bake Burner Igniter
Bake Burner
Orifice Hood
Gas Safety Valve
Assembly
Photo C
A closeup view of the bake burner igniter and harness can be seen in
photo B.
1RWHThe replacement field service igniter may have bare wire ends that
must be connected by splicing into the original connector plug harness.
Photo B