8
If the fault condition is still present, the display repeatedly scrolls
from * FIRE SYSTEM * to FIRE TROUBLE. Manually
press the [NEXT] key repeatedly to display all of the devices that are
still off-normal. When all devices return to normal the FIRE
TROUBLE display automatically clears. Check to be certain that
there is no smoke, fire, or other danger present.
If you can’t reset the detector or sensor contact your service
company.
Detector Reset Key
Description
Detection devices, such as smoke detectors, must be reset after being
activated. Pressing the [DETECTOR RESET] key momentarily
removes power from these sensors to reset them.
Detector Reset Key
After pressing this key, the display shows SENSORS RESETING
for approximately 3 seconds and then goes blank before returning
to the repeated display of * FIRE SYSTEM * followed by
ALARM SILENCED. This function clears alarm point information
from the display. The ALARM SILENCED message continues to
display as a reminder that the VIEW MEMORY ? function can still
be used to view cleared point information. Pressing the
[ANNUNCIATOR RESET] key clears both the View Memory
buffer and the ALARM SILENCED display. For more information
see the description of the VIEW MEMORY ? function (page 13).
To Next Page
Loading...
