English–1
1 619 929 413 • (01.06) T
1
13 mm Quick clamping replacement drill chuck
2
SDS-plus replacement drill chuck
3
Tool holder (SDS-plus)
4
Dust protection cap
5
Locking sleeve
6
Replacement drill chuck locking ring
7
Locking button
8
On-off switch
9
Right/Left rotation switch
10
Unlocking button
11
Operational mode selection switch
12
Auxiliary handle
13
Drill bit holder
Not all the accessories illustrated or described are in-
cluded in standard delivery.
Measured values determined according to EN 50 144.
The A-weighted noise levels of the tool are typically:
Sound pressure level: 88 dB(A)
Sound power level: 101 dB(A)
Wear ear protection!
The typical weighted acceleration is 11 m/s
2
.
The machine is intended for hammer drilling in con-
crete, brick and stone as well as for light chiselling
work. It is also suitable for drilling without impact in
wood, metal, ceramic and plastic.
Machines with electronic control and right/left rotation
are also suitable for screw driving and thread cutting.
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
In addition, the general safety instructions in the
enclosed booklet must be followed.
Before using for the first time, ask for a practical
demonstration.
If the cable is damaged or cut through
while working, do not touch the cable
but immediately pull the mains plug.
Never use the machine with a dam-
aged cable.
Wear ear protection to prevent damage
to your hearing.
Wear safety glasses and sturdy shoes.
For long hair, wear hair protection.
Work only with close-fitting clothes.
■
Connect machines that are used outdoors by
means of a fault current protection switch (FI) with
a maximum triggering current of 30 mA. Use only
an extension cable that is approved for outdoor
use.
■
Always direct the cable to the rear away from the
machine.
■
Insert the mains plug into the socket only when the
machine is switched off.
■
Place the machine on the nut/screw only when
switched off.
■
For screws, work using the first gear or with a low
speed.
■
Be careful when screwing in long screws; danger
of sliding off.
■
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Product Specifications
Percussion drill GBH 2-24 DFR
Order number
0 611 238 7..
Replacement drill chuck
●
Speed control
●
Right/Left rotation
●
Rated input power
[W] 620
Power output [W] 360
Impact rate [per min] 0 ... 4850
Impact energy
per stroke [J] 2.2
Nominal speed
Right rotation
Left rotation
[RPM]
[RPM]
0 ... 870
0 ... 500
Tool holder SDS-plus
●
Spindle collar diameter
[mm] 43
(Euro-Standard)
Number of chiselling positions 36
Maximum drill diameter:
Concrete/Stone
Granite
Wood
Steel
[mm]
[mm]
[mm]
[mm]
24
16
30
13
Weight (without acces-
sories) approx. [kg] 2.6
Degree of protection /
II
Product Elements
Noise/Vibration Information
Intended Use
For Your Safety
To Next Page
Loading...
