To Next PageTo Next PageWhy does Bosch GCM12SD Saw vibrate or shake?
If your Bosch Saw vibrates or shakes, consider the following: * Replace the blade if it is not round. * Replace the blade if it is damaged. * Ensure the blade is properly seated on the inner washer, referring to the Removing and Installing Blades section. * If none of these steps resolve the issue, further assistance from an authorized service may be needed.
What to do if Bosch Saw head assembly will not fully raise?
If the head assembly of your Bosch Saw will not fully raise or the blade guard will not fully close, here are some things to check: 1. Ensure the head assembly lock pin is not engaged. Pull it out to allow the head assembly to move freely. 2. Verify the cover plate is tightened after replacing the blade, referring to the Removing and Installing Blades section. 3. Clean any sawdust accumulation from the head assembly.
Why is Bosch Saw glide mechanism difficult to move?
If the glide mechanism on your Bosch Saw is difficult to move forward and back, the glide movement controller may be set too tight. Loosen the two screws on the movement controller.
General| Type | Sliding Compound Miter Saw |
|---|---|
| Blade Diameter | 12 inches |
| Amperage | 15 A |
| No Load RPM | 3, 800 RPM |
| Voltage | 120V |
| Corded/Cordless | Corded |
| Vertical Capacity (Baseboard) | 6-1/2 inches |
| Saw Blade Bore | 1 inch |
| Max Cutting Capacity at 0° | 14 inches |
| Max Cutting Capacity at 45° Miter | 10 inches |
| Weight | 65 lbs |
| Horizontal Capacity (Crown Molding) | 14 inches |
| Vertical Capacity (Crown Molding) | 6.5 in |
| Max Cutting Depth at 90° | 4 in |
| Max Cutting Width at 90° | 14 in |
| Max Cutting Width at 45° | 9.5 in |
| Power Input | 1, 800 W |
