English–31 609 929 E36 • (04.10) PS
Avoid overloading the motor especially when working
with large work pieces. When cutting, apply only light
pressure to the handle.
Pay attention to the dimensions of the cutting disk.
The hole diameter must fit on the tool spindle without
play. Do not use reducer pieces or adapters.
Do not apply sideways pressure to the cutting disk.
Observe the instructions of the manufacturer for the
mounting and usage of the cutting disk.
The cutting disk continues to run after the machine is
switched off.
Actuate the spindle locking only when the cutting disk
is at a standstill.
The cutting disk becomes very hot while working; nev&
er take hold of it before it has cooled.
Bosch can ensure flawless functioning of the machine
only when original accessories intended for the ma&
chine are used.
SYMBOLS
Important notice: Some of the following symbols could have meaning for the use of your tool. Please take note
of the symbols and their meaning. The correct interpretation of the symbols will help you to use the tool in a better
and safer manner.
Symbol Name Meaning
VVolts Voltage
A Amperes Current
Ah Ampere&hours Capacity, quantity of stored electrical energy
Hz Hertz Frequency (cycles per second)
WWatt Power
Nm Newton&meter Unit of energy
kg Kilograms Mass, weight
mm Millimetre Length
min/s Minutes/Seconds Time
°C/°F Degrees Celsius/Degrees
Fahrenheit
Temperature
dB Decibel Unit of relative loudness
∅ Diameter Size of drill bits, grinding wheels, etc.
min
&1
/n
0
Revolutions per minute/no load
speed
Rotational speed at no load
…/min Revolutions or reciprocation per
minute
Revolutions, strokes, surface speed, orbits, etc.
per minute
0 Off position Zero speed, zero torque...
SW Spanner width (in mm) Distance between parallel surfaces on fastener el&
ements on which the tool must fit on (e.g. hex nuts
or hex&head screws), fit over (e.g. ring spanner) or
fit in (e.g. socket&head screws).
Left rotation/Right rotation Direction of drive rotation
/ Hex socket drive/Square drive Type of tool holder
Arrow Action in the direction of arrow
Alternating current Type or a characteristic of current
Direct current Type or a characteristic of current
Alternating or direct current Type or a characteristic of current
To Next Page
Loading...
