English–51 609 929 E36 • (04.10) PS
3 FUNCTION
While reading the operating instruc&
tions, refer to the corresponding illus&
trations of the electro&tool on the front
pages.
Intended Use
The machine is intended for stationary use to perform
lengthways and crossways straight cuts or mitre cuts
to 45° in metal materials without the use of water.
Noise/Vibration Information
Measured values are determined according to stand&
ard EN 61 029 procedures.
The A&weighted noise levels of the tool are typically:
Sound pressure level: 99,7 dB(A)
Sound power level: 113,0 dB(A)
Measurement uncertainty K = 3 dB
Wear ear protection!
The typical weighted acceleration is 3.4 m/s
2
.
Product Specifications
Product Elements
The numbering of the machine elements refers to the
illustrations of the electro&tool on the front pages of the
operating instructions.
1 Handle
2 On/Off switch
3 Swinging guard
4 Cutting disk
5 Clamping spindle
6 Quick release
7 Crank
8 Base plate
9 Angle stop
10 Angle stop bolts
11 Locking nut for depth stop
12 Depth stop
13 Tool arm
14 Spindle lock
15 Overload switch *
16 Transport handle
17 Tool spindle
18 Cutting disk cover
19 Clamping flange
20 Washer
21 Hex&head bolt
22 Screw for cutting disk cover
23 Open&end spanner
24 Transport locking pin
Not all the accessories illustrated or described are in
cluded in standard delivery.
*
Not included for 0 601 B10 041 (UK execution)
CutOff and Mitre Saw GCO 141
PROFESSIONAL
Order number
0 601 B10 …
… 003
… 008
… 042
… 032 … 037 … 041
Rated input power [W] 2 400 2 300 2 400 2 000
Voltage [V] 230 230 240 110
Frequency [Hz] 50 50 50 50
No load speed [min
&1
] 3 500 3 500 3 500 3 500
Tool spindle [mm] 25.4 25.4 25.4 25.4
Weight
(according to EPTA Procedure 01/2003)
[kg] 21 21 21 21
Cutting disk dia. [Inch] 14 14 14 14
Protection class / I / I / I / I
For maximum work piece dimensions, see the "Working Instructions" Section
To Next Page
Loading...
