English | 27
Bosch Power Tools 1 609 929 U62 | (8/24/10)
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Minimal workpiece sizes
(= all workpieces that can be clamped via the
clamping spindle 8):
Length 80 mm
Cutting capacity, max. (0°/0°): 125 mm
Cutting Metal
– Set the desired mitre angle.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Switch on the machine.
– Slowly guide the tool arm downward with the
handle 3.
– Cut the workpiece applying uniform feed.
– Switch the machine off and wait until the cut-
ting disc comes to a complete stop.
– Guide the tool arm slowly upward.
Adjusting the Depth Stop (see figure H)
In the delivery condition of the machine, the
depth stop 16 is adjusted in such a manner that
a new 355 mm cutting disc does not touch the
base plate when cutting.
To compensate the wear of the cutting disc, the
depth stop can be set deeper.
When using a new cutting disc, the depth stop
must then always be set back to the original po-
sition.
f Always adjust the depth stop in such a man-
ner that the cutting disc does not touch the
base plate when cutting.
– Bring the power tool into the working posi-
tion. (see “Releasing the Machine (Working
Position)”, page 25)
– Loosen lock nut 25 with the supplied ring
spanner 14 (13 mm).
– Swing the tool arm with the handle 3 to the
requested position.
– Screw the depth stop 16 in clockwise or an-
ticlockwise direction until the screw head
touches the housing.
– Slowly guide the tool arm upward and tight-
en the lock nut 25.
Transport
– Always carry the power tool by its transport
handle 18.
f The power tool should always be carried by
two persons in order to avoid back injuries.
f When transporting the power tool, use only
the transport devices and never use the
protective devices.
Maintenance and Service
Maintenance and Cleaning
f Before any work on the machine itself, pull
the mains plug.
f Clean the ventilation slots of your power
tool regularly with a soft brush. The motor
fan draws dust into the housing, and a large
accumulation of metal dust can lead to elec-
trical hazards.
f In extreme conditions, always use dust ex-
traction as far as possible. Blow out ventila-
tion slots frequently and install a residual
current device (RCD). When working metals,
conductive dust can settle in the interior of
the power tool. The total insulation of the
power tool can be impaired.
Mitre/Bevel Angle
Workpiece Form 0° 45°
125 Ø 100 Ø
110 x 110 82 x 82
180 x 85 90 x 75
130 x 130 75 x 75
OBJ_BUCH-1063-002.book Page 27 Tuesday, August 24, 2010 10:05 AM
To Next Page
Loading...
