Need help?Do you have a question about the Bosch Geothermal Heat Pumps and is the answer not in the manual?
Describes self-contained and split-system water-to-air heat pump models offered by Bosch.
Explains the heating and cooling cycle operations of Bosch water-to-air geothermal heat pumps.
Covers the critical process of accurately sizing geothermal heat pump equipment for optimal performance.
Details the principles and components of open-loop geothermal heat pump systems utilizing groundwater.
Explains closed-loop systems, the most common type for residential geothermal applications.
Details recommended piping types, materials, and installation standards for closed-loop geothermal systems.
Covers essential procedures, materials, and considerations for constructing boreholes for vertical closed-loop systems.
Details various horizontal loop layout designs, spacing recommendations, and depth considerations.
Provides critical safety guidelines and OSHA requirements for working in trenches during ground loop installation.
Describes pressurized flow centers, their components, and installation advantages.
Explains non-pressurized flow centers and their operational benefits for fluid circulation.
Provides essential guidelines for accurately sizing Bosch water-to-water geothermal heat pumps based on load calculations.
Details proper piping design considerations, material selection, and insulation for water-to-water heat pumps.
Describes the Hot Gas Reheat (HGR) option for maintaining specific humidity levels in conditioned spaces.
Explains the Comfort Alert diagnostic module used for troubleshooting heat pump and HVAC system failures.
Describes the Soft Start device, an option to reduce compressor starting current and improve system reliability.
Details systems that integrate geothermal heat pumps with solar thermal water heating for enhanced efficiency.
Highlights the Serenbe Experience Center as a hub demonstrating Bosch home and commercial building energy systems.
To Next Page
General