English | 13
Bosch Power Tools 2 609 141 167 | (15.4.14)
After the second measurement has been completed, the area
will be automatically calculated and displayed. The end result
will be shown at the bottom of the display, while the current
measured value will be shown above it.
Volume Measurement
For volume measurements, repeatedly press button 4 until the indicator for volume
measurement appears on the display 1.
Then measure the width, length and depth one after the other as with a length meas-
urement. The first measured value will be shown at the bottom of the display. The la-
ser beam remains switched on between the three measurements.
After the third measurement has been completed, the volume
will be automatically calculated and displayed. The end result
will be shown at the bottom of the display, while the current
measured value will be shown above it.
Simple Pythagoras Measurement
For Pythagoras measurements, repeatedly press button 4 until the indicator for
Pythagoras measurement appears on the display 1.
Make sure that there is a right angle between the sought distance (height) and the hor-
izontal distance (depth)! Then measure the depth and diagonal one after the other as
with a length measurement. The first measured value will be shown at the bottom of
the display. The laser beam remains switched on between the two measurements.
After the second measurement has been completed, the height
will be automatically calculated and displayed. The end result
will be shown at the bottom of the display, while the current
measured value will be shown above it.
Deleting Measured Values
Briefly pressing the On/Off button 5 will delete the last measured value in all measur-
ing functions. Repeatedly pressing the On/Off button 5 briefly will delete the meas-
ured values in reverse order.
OBJ_BUCH-2181-001.book Page 13 Tuesday, April 15, 2014 10:12 AM
To Next Page
Loading...
