pressing the button a second time
deletes all lengths B
X
, and
pressing the button a third time
deletes all room heights A.
Adding Measured Values
To add measured values, firstly
carry out any measurement or
select an entry from the measured
value list. Then press the plus
button 11. For confirmation, “+”
appears on the display. Then carry
out a second measurement or
select another entry from the
measured-value list.
To call up the sum
of both
measuremen ts,
press the result
button 6. The
calculation is
indicated in the
measured-value lines a, and the
sum in the result line c.
After calculation of the sum,
further measured values or
measured-value list entries can be
added to this result when pressing
the plus button 11 prior to each
measurement. Pressing the result
button 6 ends the addition.
Notes:
– Mixed length, area and volume
values cannot be added
together. For example, when a
length and area value are
added, “ERROR” briefly
appears on the display after
pressing the result button 6.
Afterwards, the measuring tool
switches back to the last active
measuring mode.
– For each calculation, the result
of one measurement is added
(e.g. the volume value); for
continuous measurements, this
would be the displayed
measured value in result line c.
The addition of individual
measured values from the
measured-value lines a is not
possible.
Subtracting Measured Values
To subtract
measuring values,
press minus button
5; For confirmation,
“–” is indicated on
the display. The
further procedure
is analog to “Adding Measured
Values”.
Working Advice
General Information
The reception lens 17 and the
laser beam outlet 16 must not be
covered when taking a
measurement.
The measuring tool must not be
moved while taking a
measurement (with the exception
of the continuous measurement
and grade measurement
functions). Therefore, place the
measuring tool, as far as this is
possible, against or on a firm stop
or supporting surface.
-28-
To Next Page
Loading...
