18
Connectivity
Bluetooth®
Do not use the power
tool with Bluetooth® in
the vicinity of gas stations, chemical
plants, areas where there is danger of
explosion and areas subject to blasting.
Do not use the power tool with
Bluetooth® in airplanes. Do not use the
power tool with Bluetooth® in the vicinity
of medical devices. Avoid operation in the
direct vicinity of the human body over
longer periods of time. When using the
power tool with Bluetooth®, interference
with other devices and systems, airplanes
and medical devices (e.g., cardiac
pacemakers, hearing aids) may occur.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by
Robert Bosch Tool Corporation is under
license.
Follow all instructions
and warnings provided
by your Bluetooth® device manufacturer.
Failure to follow recommended procedures
could result in personal injury or property
damage.
Exercise extreme
caution when using
Bluetooth® devices to control or change
power tool functions. Operation of the
device may be in a different area than the
paired power tool. Paired devices may have
functionality which allows timed event
programming, including automatically
powering on (e.g. flood light). Depending
upon the power tool, these unattended
operations or function changes without
direct line of sight to the paired tool could
result in personal injury or property
damage.
Always check tool
settings before use.
Settings may be different than when the
tool was last used. The connectivity module
enables transfer of data and settings based
on Bluetooth® wireless technology. With
module installed, select tool settings may
be changed remotely by a paired
Bluetooth® device and user installed app.
The connectivity module
GCY42 is equipped with
a radio interface. Local operating
restrictions, e.g. in military sites or
hospitals, are to be observed. Transmitters
have demonstrated an ability to
unintentionally interfere with other devices.
Think Safety
SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TOOL IS BEING USED.
To reduce the risk of injury read the operating instructions included with
Bosch GCY42 connectivity module. Operating instructions for GCY42
connectivity module include important information not covered in this manual.
If a tool angle is within +/-3° of the preset
slope angle, the LED(8) lights up green. To
end the leveling function, press the button
for the leveling function (18) repeatedly
until none of the LEDs for angle
selection(19) are lit up (45° → 60° → User-
defined → Off). The set angle and
reference surface are saved even when
changing the battery or when waking up
the power tool from sleep mode.
BUILT IN LED WORK LIGHT
Your tool is also equipped with an LED light
(23) that turns on automatically when the
switch is activated, for better visibility
when drilling/ driving (Fig. 15). The light
turns off automatically a short time after
the trigger is released. You can adjust this
time frame using Bosch Tool Box app. See
“Connectivity” section.
Operating Instructions
2610056705 GSB18V-1330C 04-21.qxp_GSB18V-1330C GSR18V-1330C 5/3/21 7:00 AM Page 18
To Next Page
Loading...
Need help?
General
