Bosch GTS 10 J Professional - Storage and Transport

English | 49
Bosch Power Tools 1 609 929 X56 | (22.1.11)
Storage and Transport
Storing Product Features (see figures Y1–Y6)
For storage purposes, certain product features
can be securely fastened to the power tool.
– Loosen auxiliary parallel guide 37 from paral-
lel guide 10.
– Attach all loose tool parts to their storage lo-
cations on the housing. (see Table)
Carrying the Power Tool
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion. (see “Transport Position”, page 44)
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Slide the saw-table extension 14 completely
to the rear and press tensioning lever 15
downward to lock it.
– Wind the mains cable around the cable hold-
er 29.
– For lifting or transport, use the recessed
handles 4 or the carrying handle 13.
f When transporting the power tool, use only
the transport devices and never use the
protective devices.
f The power tool should always be carried by
two persons in order to avoid back injuries.
Figure Product Feature Storage Location
Y1 Blade guard 6 Insert into the recess of fixture 33 and tighten with clamp-
ing lever 8
Y2 “Auxiliary parallel guide”
fastening kit 38
Clip into the holders 65
Y2 Extraction adapter 32 Insert into retaining clamp 66
Y3 Ring spanner 22 Fasten in tool depot with fastening nut 67
Y3 Push stick 23 Mount onto fastening nut 67 and fasten by turning
Y4 Parallel guide 10 Turn guide around and hang it into the guide rails from be-
low; tighten clamping handle 35
Y5 Allen key 21
Allen key 64
Insert into holders 68
Y5 Angle stop 3 Insert into retaining clamp 69
Y6 Auxiliary parallel guide 37 Insert into retaining brackets 30 (short side goes on top;
long side toward the rear)
OBJ_BUCH-1325-001.book Page 49 Saturday, January 22, 2011 12:54 PM