-15-
Abrasive Type 41/1A and 27A/42
Wheel Assembly
Using the Type 41/1A wheel guard (sold separately), it
is possible to perform limited cutting on small stock such
as metal tubes, piping or rebar.
Do not attempt to cut large stock or sheets of metal as
this tool is not designed to be a dedicated cutting tool.
Always use Type 41/1A
protection guard for cutting.
1. Disconnect battery pack from tool.
2. Be sure that wheel guard is in place for cutting.
When using mounting wheels, place the BACKING
FLANGE on the spindle and then place the WHEEL on
the spindle.
3. Thread on the lock nut and tighten nut using the lock
nut wrench, while holding the spindle lock. (Fig. 6).
TO REMOVE: Reverse procedure.
Type 1 Abrasive Straight Grinding
Wheels
Do not use Type 1 abrasive
wheels designed for straight/
die grinding. This tool is not designed for use with Type
1 abrasive straight/die grinding wheels.
Type 41/1A
Wheel Guard
(sold separately)
Spindle
Backing
Flange
Type 41/1A
Cutting Wheel
Fig. 6
Type 27A/42
Cutoff Wheel
Lock Nut
Assembly
To Next Page
Loading...
