-16-
Sanding Accessories Assembly
BACKING PAD
Before attaching a backing pad
be sure its maximum safe
operating speed is not exceeded by the nameplate
speed of the tool.
Wheel guard may not be used
for most sanding operations.
Always reinstall wheel guard when converting back to
grinding operations.
Do not use the quick -
Clamping Nut with backing pad
for sanding accessories.
TO INSTALL BACKING PAD AND
SANDING DISC (sold separately)
Disconnect battery pack from tool.
Attach hand guard (Fig. 1). Set the tool on its top side
(spindle up). Place the rubber backing pad onto the
spindle shaft. Center the sanding disc on top of the
backing pad. Insert the lock nut (sold separately)
through the disc and thread onto the spindle as far as
you can with your fingers. Press in the spindle lock, then
tighten the backing pad securely with lock nut wrench
(Fig. 7).
TO REMOVE: Reverse procedure.
Wire Brush Assembly
Before assembling wire brush to this tool, disconnect
from the power source. Attach hand guard (Fig. 1). Wire
brushes are equipped with their own threaded hub,
simply thread on to spindle. Be sure to seat against
shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
Wire Wheel Assembly
Before assembling wire wheel to this tool, disconnect
from the power source. Attach type 27 guard (Fig. 8).
Wire wheels are equipped with their own threaded hub,
simply thread on to spindle. Be sure to seat against
shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
Sanding
Disc
Backing
Pad
Lock Nut
(sold separately)
Wire Brush
Spindle
Fig. 7
Assembly
SPINDLE
TYPE 27
WHEEL GUARD
WIRE WHEEL
FIG. 8
To Next Page
Loading...
