-18-
Masonry Cutting Guard
Assembly
A type 27 grinding wheel guard
may not be used for all tool
operations. Do not discard guard when not in use.
Always reinstall wheel guard when converting back to
grinding operations.
To improve ergonomics of your grinder when cutting
masonry, gearbox must be rotated relative to the
position of the switch as the tool was assembled at the
factory.
ROTATE GEARBOX (Fig. 10)
1. Unplug tool from power source.
2. Completely unscrew the four screws between the gear
housing and motor body.
3. Rotate gear housing to the proper orientation without
removing motor from the housing.
For the slide switch models, rotate gear housing 180
degrees in the direction indicated in Fig 11, so the
switch is 90 degrees from the spindle.
4. Screw in and tighten the four screws you removed.
5. The screw holding the quick release lever is longer
than the other screws, this long screw must stay
with the quick release lever when re-attaching gear
housing for the quick release button to operate
properly.
6. Attach proper dust collection guard with foot and
accessory.
INSTALLING MASONRY TYPE 1
CUTTING GUARD
1. Use tool adjusted as show in figures 10 and 11.
2. Unplug tool from power source.
3. Unscrew and remove side handle.
4. Slide dust extraction guard on spindle neck.
5. Rotate attachment until stability bracket and hole for
side handled are aligned.
4x
FIG. 10
Slide
switch
180
degrees
180
degrees
FIG. 11
Spring
Guard
release
lever
(x3)
Assembly
To Next Page
Loading...
