-19-
Assembly
6. Screw in side handle to secure stability bracket
between the tool housing and handle.
7. Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
INSTALLING DRY DIAMOND WHEEL
(Fig. 12)
1. Place the backing flange on the spindle. Turn flange
until it locks with the base of the spindle.
2. Place the dry diamond wheel onto the spindle and
align the arbor hole of the grinding wheel with the
shoulder of the backing flange.
3. Tighten lock nut with supplied lock nut wrench while
holding spindle lock.
TO REMOVE: Reverse procedure.
FIG. 12
Spindle
Lock nut
Backing
flange
Dry
diamond
wheel
Lock nut
Backing
flange
Spindle
Dry diamond
wheel
To Next Page
Loading...
