-20-
Operating Instructions
Hold the tool with both hands
while starting the tool, since
torque from the motor can cause the tool to twist.
Start the tool before applying to work and let the tool
come to full speed before contacting the workpiece. Lift
the tool from the work before releasing the switch. DO
NOT turn the switch “ON” and “OFF” while the tool is
under load; this will greatly decrease the switch life.
Side On-Off Switch
with Lock
The tool is switched “ON” by the side switch located at
the side of the motor housing (Fig. 13). The switch can
be locked in the “ON” position, a convenience for long
grinding operations.
To turn the tool “ON” without locking it, move the switch
forward by applying pressure ONLY at the REAR portion
of the switch. When pressure is released the switch will
return to “OFF” position.
TO LOCK THE SWITCH “ON”, move the switch forward
and press the FRONT portion.
TO UNLOCK THE SWITCH, simply press and release the
REAR portion of the slider. Switch is spring loaded and
will snap back automatically.
Side
Switch
Fig. 13
To Next Page
Loading...
