Installation/Operating instructions (IO)
4 boiler control, DHW, BACnet and Modbus
Heatronic 4000
IO Heatronic 4000 2014/04 en-us
To avoid serious personal injury or property damage:
•
Read Manual and all product labels BEFORE using this product and follow all safety and
use information. Failure to do so could result in personal injury or property damage.
•
Do not use unless you know the safe and proper operation of equipment required for
installation.
•
It is the installers responsibility to ensure that this product is safely installed according
to all applicable codes and standards.
The Heatronic 4000 is designed to operate up to four boilers to
accurately maintain a target water temperature. The Heatronic
4000 operates both condensing & non-condensing boilers that
are either modulating, single stage two stage or dual fuel to
provide a flexible, cost effective mixed boiler plant solution
with better system performance.
The target water temperature is based on outdoor temperature
reset or a fixed setpoint for space or process heating applications.
Additional loads supplied by the Heatronic 4000 include
domestic hot water heating. Boiler equal run-time rotation,
stand-by primary pump operation & pump exercising all
increase boiler plant reliability.
The Heatronic 4000 communicates with a Building Automation
System (BAS) using BACnet
®
IP or Modbus
®
for remote
monitoring & adjustment capability.
Features
•
Control and monitor up to 4 boilers, condensing,
non-condensing, or a mix
• BACnet
®
IP or Modbus
®
Compatible
• Programmable Scheduling
• DHW priority
• Outdoor Temperature Reset
•
Compatible with modulating, singe stage, two stage
and dual fuel burners
• Compatible with NG, LPG & Oil Burners
• Programmed boiler default parameters
To Next Page
Need help?
General
