Bosch HPC 400 User Manual

Overview of control elements and symbols
@ BOSCH
~ Fig . 1, page 5
Item Element
Designation Explanation
~
ac
ey ress 0 re urn 0
e Ig er menu eve or Iscar a c ange
va ue.
==
If the need for a service or a fault is displayed :
~
Press to switch between standard display and fault display.
6
B kk
t th h h
I d d h d I
~ P
~
Hold to switch from a menu to the standard display.
'] -:
--
0
Selector
~
Turn to change a setting value (e .g. temperature) or select from among the menus or
menu items .
If the lighting is switched off :
~
Press to switch the lighting on.
If the lighting is switched on :
~ Press to open a selected menu or menu item. confirm a set value (e .g. temperature)
or a message or to close a pop - up window .
If the standard display is active :
~ Press to activate the inputfield for selecting the heating circuit in the standard display
(systems with at least two heating circuits only . ~ Chapter 4. 1. page 9) .
-
Table 2 Control elements
6 HPC400-6720821983(2017/07)
BOSCH
Overview of control elements and symbols
®~----{(I We, 19.03.2014 14:13 I)
~ Q [40~cJ[12.~~ 'Jr----®
r
Flow temperature
HC1 Prog. 1 -:9:-
6720811136·901. 10
Fig . 2 Example [or a standard display of a system with more than one heating circuit
[1] Temperature
[2] Information line
[3] Outside temperature
[4] Text information
[5] Key lo ck
[6] Information graphic
[7] Mode
2
3
Information line
T Additional
temperature
display
f----If- -===- --+-
4 T exti nformation
5
Key lock
Table 3 Symbols on the standard display
Displays theheat source flow temperature or
the room temperature if a remote control is installed for the displayed heating
circuit.
Display of time of day. day of the week and date .
1 Display of an additional temperature : outside temperature. temperature of the
solar collector or a DHW system (for further information ~ page 30) .
E.g. the designation of the temperature currently displayed (~ Fig . 2. [1]). If a
fault is present. corresponding information will be displayed here until the fault
has been rectified .
When the key is displayed. this means that the key lock is enabled (~page 11.
7).
HPC 400 - 6 720 821983 (2017/07) 7

Bosch HPC 400 Specifications

General

Brand	Bosch
Model	HPC 400
Category	Control Panel
Language	English