4. Powering up is done when the bonding pads are short-circuited.
5. Quick flash of the red LED indicator on the printed circuit board of the control panel
indicates that the factory Default will be reset.
6. All programming parameters are reset to factory default immediately after releasing the
short-circuited bonding pads.
Notice!
If the DEFAULT pads are short-circuited for over 10 seconds after power-up, the control panel
will discard resetting to factory Default.
LCD Menu Programming
For menu programming with LCD keypad, see Section 4.1.1 LCD Keypad Menu Programming
on page 10.
Use [▼] and [▲] to move main menus, submenus and secondary submenus up or down.
Use [-] and [#] to move main menus, submenus and secondary submenus left or right.
4.3
12 en | Configuration
AMAX panel 4000 / AMAX panel 4000
EN
2013.07 | 03 | F.01U.267.113 Quick Start Guide Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
