Why aren't the keypad and alarm siren responding when a zone triggers an alarm on my Bosch Security System?
If there is no response from the keypad and the alarm siren is disabled when a zone triggers an alarm, it might be because the zone silent alarm is enabled. Disable the zone silent alarm.
Why can't my Bosch Security System control panel send reports to the receiver?
The control panel might not send reports if the transmission format of the receiver is programmed to 0, which means 'not used.' Program the transmission format of the receiver to 1 or 3.
Why A-LINK cannot be connected with ITS- DX4020-G Bosch Security System?
A-LINK connection issues with ITS-DX4020-G can arise from improperly set parameters on the ITS-DX4020-G. It is recommended to set the ACK TIMEOUT parameter of ITS-DX4020-G to the maximum value (600) and set TRANSMIT BUFFER LIFE TIME to the maximum value (120).
General| Series | AMAX |
|---|---|
| Model | ICP-AMAX4-P2-EN |
| Manufacturer | Bosch |
| Max Zones | 64 |
| Communication | Ethernet, PSTN |
| Operating Temperature | -10°C to +55°C |
| Product Type | Control Panel |
| Battery Backup | 7 Ah |
| Compliance | EN50131 Grade 2 |
Procedures and indications after the system is powered up or reset.
Indication of system status via LED on the main board.
Support for programmable 4- to 6-digit Installer and User Codes.
Requirements for EN 50131-3 Grade 2 certification compliance.
Methods for programming the system using keypads.
Procedure for programming via LCD keypad menu.
Procedure for programming addresses via LED/Icon LCD keypad.
Procedure to reset the control panel to factory default settings.
Navigation and operation for LCD menu programming.
Configuration of system addresses for various functions.
Configuring communication parameters and report options.
Configuration of zone functions, areas, and modules.
Setting up output event types, modes, and times.
Setting up code length and installer codes.
Configuration of system parameters like exit and entry delay.
To Next Page