Service
b7 The
Operation in essence
tie
operation
– The number of times the device is
opened
– Load quantity
– Temperature
of the freshly
stored food
- Ambient temperature
– Direct sunlight
Service
7.1 Switch on device
1.
Connect the device electrically.
→
Page 12
7.3 Switch off machine
Remark:
If the device was previously
switched off via the control panel,
Press and hold for 3 seconds. a
The device
starts to cool. aA
warning signal sounds
needle, the
temperature display (freezer
compartment) and blink because
the freezer compartment is still too warm.
▶ Pressed for 3
seconds
to hold.
7.4
Set temperature
Set
refrigerator compartment temperature
▶ Press the
desired temperature.
2.
The warning signal with
Switch off.
The
recommended temperature in the
refrigerator compartment is 4 °C.
a turns
off once the set
temperature has been reached.
Set freezer
compartment temperature
▶ Press the
desired temperature.
3.
Set the desired temperature.
→
Page 16
The recommended temperature in the
freezer compartment is −18 °C.
7.2
Notes on use
¡
When you have switched on the device
switched on, it takes up to several
hours before the set temperature is
reached.
Do not place food in the appliance
before the set temperature has
been reached.
¡The front sides of the housing
are temporarily slightly heated. This
prevents condensation from
forming in the door seal area.
¡When you close the door, a
under pressure arises. It just makes
the door more difficult to open. Wait
a moment until
the negative
pressure is compensated.
¡The temperature in the device
is governed by the following conditions:
8
Additional features
Find out which customizable
additional functions your device has.
8.1
Super cooling
With
Super cooling, the refrigerator compartment cools
as
cold as possible.
Switch on Super Cool before loading
large quantities of food.
Remark:When Super Cooling is on,
more noise may be produced.
Switch
on super cooling
▶ Press
a
.
burns.
16
To Next Page
Loading...
