EasyManua.ls Logo

Bosch MR 12 - Time and Alarm Configuration; Clock Time Display and Setting; Alarm Function Setup

Bosch MR 12
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en | 37
7 620 210 017 | 11.2013Robert Bosch Car Multimedia GmbH
en
Time
Displaying the time
In order to display the time for about 10 sec-
onds,
f Hold down the MENU
5
button for
longer than 2 seconds.
Note:
Depending on the selected clock
mode, either "24H" will be shown in
front of the time when in 24-hour
mode, or, in 12-hour mode, "AM" (in
the morning) or "PM" (in the
afternoon).
Read the section on "Selecting
12/24-hour clock mode" in this
chapter to see how to set the clock
mode.
Setting the time (TIMESET)
f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "TIMESET" appears on the display
along with the current setting.
The current time will be shown on the display
after about 2 seconds. Either "24H" will be
shown in front of the time when in 24-hour
mode, or, in 12-hour mode, "AM" (in the
morning) or "PM" (in the afternoon). The hours
flash, and can be adjusted.
To adjust the hours or minutes,
f Turn the volume control
1
to the left or
right.
To switch between hours and minutes
f Press the 6 : button.
f Press the MENU 5 button, repeatedly if
necessary, to close the menu.
Selecting 12/24-hour clock mode
(MODE)
f Press the MENU 5 button to open the
menu.
f Press the MENU 5 button repeatedly
until "MODE" appears on the display along
with the current setting.
f Turn the volume control
1
to the left or
right in order to change between the
settings.
f Press the MENU
5
button, repeatedly if
necessary, to close the menu.
Switching the alarm on/off and
adjusting the alarm time (ALARM)
You can set an alarm time on the device for a
one-off alarm. An alarm signal will then sound
at the set time for about 15 seconds and
ALARM” will flash on the display.
Note:
f To cancel the sounding alarm
signal, press any button (other
than the On/Off button). The
device then switches to normal
operating mode.
f The alarm is also given if the
device is already switched on at
the time of the alarm.
f Press the MENU 5 button to open the
menu.
Time
02_MR12_en.indd 37 25.11.13 16:23

Table of Contents

Related product manuals