EasyManua.ls Logo

Bosch MR 12 - Radio Scanning Functions; Preset Station Scanning (PRSTSCAN); Receivable Station Scanning (BANDSCAN)

Bosch MR 12
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en | 41
7 620 210 017 | 11.2013Robert Bosch Car Multimedia GmbH
en
replaced by newly found
stations.
f If priority for traffic information
is active, only stations that carry
traffic information will be saved.
f If PTY is activated, the next
station of the selected program
type is selected.
f Select the desired waveband.
f Press and hold down the BND
2
button
for longer than two seconds.
The storing procedure begins. The display
shows “T-STORE”. After the process has
completed, the radio will play the station that
is stored in memory location one of the FMT,
AMT, MWT or LWT memory banks.
Listening to stored stations
f Select the memory bank or waveband.
f Press the station button 1 – 6 : where
the desired station is stored.
Scanning through the preset sta-
tions (PRSTSCAN)
This function allows you to hear all the stored
stations for about 10 seconds each.
Note:
This function is only available if the
"PRSTSCAN" setting for the or
6
buttons has been selected in the
menu (see the section on "Setting
button functions" in this chapter).
Starting the scan
f Press the or
6
button.
"PRSTSCAN" briefly appears on the display.
Each station saved in the current memory bank
is played for about 10 seconds. At the same
time, the display shows the current frequency
or the station name.
Stopping scan
f Press the or
6
button.
The scan process is stopped. The device
remains tuned to the previously played station.
Scanning receivable stations
(BANDSCAN)
This function allows you to scan all receivable
stations each for about 10 seconds.
Note:
This function is only available if the
"BANDSCAN" setting for the or
6
buttons has been selected in the
menu (see the section on "Setting
button functions" in this chapter).
Starting the scan
f Press the or
6
button.
"BANDSCAN" briefly appears on the display.
The device searches for stations in the current
waveband. Every station found is played for
about 10 seconds. At the same time, the
display shows the current frequency or the
station name.
Stopping scan
f Press the or
6
button.
The scan process is stopped. The device
remains tuned to the previously played station.
Radio operation
02_MR12_en.indd 41 25.11.13 16:23

Table of Contents

Related product manuals