40 | English
1 609 929 T11 | (18.1.10) Bosch Power Tools
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the provided
quick-action clamp 7):
145 x 40 mm (length x width)
Cutting capacity, max. (0°/0°): 100 mm
Cutting Off
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Adjust the requested horizontal and/or verti-
cal mitre/bevel angle.
– Switch on the machine.
– Press lever 3 and slowly guide the tool arm
downward by handle 1.
– Saw through the workpiece applying uniform
feed.
– Switch off the machine and wait until the
saw blade has come to a complete stop.
– Guide the tool arm slowly upward.
Sawing Workpieces of the Same Length
(see figure G)
The length stop 44 can be used for easily sawing
workpieces to the same length.
– Move the length stop 44 on the extension bar
43 toward the saw blade to the desired clear-
ance.
Special Workpieces
When sawing curved or round workpieces,
these must be especially secured against slip-
ping. At the cutting line, no gap may exist be-
tween workpiece, fence and saw table.
Provide for special fixtures, if required.
Replacing the Insert Plate (see figure O)
The red insert plate 8 can become worn after
long use of the power tool.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew screws 48 with the provided Phil-
lips screwdriver 21 and remove the old insert
plate.
– Insert the new insert plate and screw in all
screws 48 again.
– Set the vertical bevel angle to 0° and saw
through the insert plate.
– Afterwards, set the vertical bevel angle to
45° and saw into the cut again.
This procedure achieves that the insert plate
is as close as possible to the teeth of the saw
blade without touching it.
Mitre/Bevel Angle Height x Width
[mm]
Horizontal Vertical at max.
height
at max.
width
0° 0°
100 x 150 63 x 196
45° 0°
104 x 105 63 x 137
0° 45°
66 x 150 44 x 194
45°
(leftward)
45°
57 x 117 38 x 134
45°
(rightward)
45°
50 x
117,5
38 x 134
OBJ_BUCH-1040-001.book Page 40 Monday, January 18, 2010 12:35 PM
To Next Page
Loading...
