English | 39
Bosch Power Tools 1 609 929 T11 | (18.1.10)
Adjusting with Help of the Fine Scale
With the fine scale 10, the horizontal mitre angle
can be set with an accuracy of up to ¼°.
Example: In order to adjust a 40.5° mitre angle,
the ½° mark of the fine scale 10 must be
brought into alignment with the 42° mark of
scale 9.
Adjusting Standard Vertical Bevel Angles
(see figure L)
For quick and precise adjustment of commonly
used bevel angles, stops are provided for 0°,
45° and 33.9° angles.
– Loosen the clamping lever 32.
– Standard angles 0° and 45°:
Tilt the tool arm by the handle 1 to the right
stop (0°) or to the left stop (45°).
– Retighten the clamping lever 32 again.
– Standard angle 33.9°:
Pull adjustment knob 31 completely outward
and turn it by 90°. Now tilt the tool arm via
the handle 1 until the tool arm can be heard
to engage.
Adjusting Any Vertical Bevel Angle
The vertical bevel angle can be set in the range
from 0° to 45°.
– Loosen the clamping lever 32.
– Tilt the tool arm by the handle 1 until the an-
gle indicator 47 indicates the desired bevel
angle.
– Hold the tool arm in this position and retight-
en the clamping lever 32.
Starting Operation
Switching On (see figure M)
–To start the machine, press the On/Off
switch 2 and keep it pressed.
Note: For safety reasons, the On/Off switch 2
cannot be locked; it must remain pressed during
the entire operation.
The tool arm can only be guided downward
when pressing lever 3.
–For sawing, you must additionally press lever
3 in addition to actuating the On/Off switch.
Switching Off
–To switch off the machine, release the
On/Off switch 2.
Working Advice
General Sawing Instructions
f For all cuts, it must first be ensured that the
saw blade at no time can come in contact
with the fence, screw clamps or other ma-
chine parts. Remove possibly mounted aux-
iliary stops or adjust them accordingly.
Protect the saw blade against impact and shock.
Do not subject the saw blade to lateral pressure.
Do not saw warped/bent workpieces. The work-
piece must always have a straight edge to face
against the fence.
Long workpieces must be underlaid or support-
ed at their free end.
Position of the Operator (see figure N)
f Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
– Do not cross your arms when operating the
tool arm.
Requested
setting of the
initial angle X
Fine scale
mark
(scale 10)
... bring into
alignment with
the mark
(scale 9)
X.25° ¼° X + 1°
X.5°
½° X + 2°
X.75°
¾° X + 3°
OBJ_BUCH-1040-001.book Page 39 Monday, January 18, 2010 12:35 PM
To Next Page
Loading...
