Bosch Professional GCM 12 - Page 42

42 | English
1 609 929 T11 | (18.1.10) Bosch Power Tools
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the
standard mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
Settings Placed
against
the fence
Lying flat
on the
saw table
Vertical bevel angle 0° 33,9°
Ceiling strip/moulding
Left side Right side Left side Right side
Inner corner Horizontal mitre
angle
45° right 45° left 31.6° right 31.6° left
Positioning of
workpiece
Bottom edge
against the
fence
Bottom edge
against the
fence
Upper edge
against the
fence
Bottom edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the left of
the cut
... to the left of
the cut
Outer corner Horizontal mitre
angle
45° left 45° right 31.6° left 31.6° right
Positioning of
workpiece
Bottom edge
against the
fence
Bottom edge
against the
fence
Bottom edge
against the
fence
Upper edge
against the
fence
The finished
workpiece is lo-
cated...
... to the right
of the cut
... to the left of
the cut
... to the right
of the cut
... to the right
of the cut
52°
38°
52°
OBJ_BUCH-1040-001.book Page 42 Monday, January 18, 2010 12:35 PM