English | 43
Bosch Power Tools 1 609 929 T11 | (18.1.10)
Checking and Adjusting the Basic
Adjustment
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
A Bosch after-sales service station will handle
this maintenance task quickly and reliably.
Aligning the Fine Scale (see figure P)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 15 to the 0° detent 14.
The lever 13 must be felt to engage in the de-
tent.
Checking:
The 0° mark of the fine scale 10 must be in align-
ment with the 0° mark of the scale 9.
Adjusting:
– Remove the insert plate 8.
– Loosen screw 49 with the provided Phillips
screwdriver 21 and align the fine scale along-
side the 0° marks.
– Retighten the screw again.
Setting the Standard Bevel Angle 0°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 15 to the 0° detent 14.
The lever 13 must be felt to engage in the de-
tent.
Checking: (see figure Q1)
– Adjust an angle gauge to 90° and position it
on the saw table 15.
The leg of the angle gauge must be flush with
the saw blade 5 over the complete length.
Adjusting: (see figure Q2)
– Loosen the clamping lever 32.
– Loosen the lock nut of stop screw 23 with
the provided ring spanner 35 (13 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 32 again.
– Afterwards, retighten the lock nut of the stop
screw 23 again.
When the angle indicator 47 is not in line with
the 0° mark of scale 51 after adjusting, loosen
screw 50 with the provided Phillips screwdriver
21 and align the angle indicator alongside the 0°
mark.
Setting the Standard Bevel Angle 45°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 15 to the 0° detent 14
.
The lever 13 must be felt to engage in the de-
tent.
– Loosen the clamping lever 32 and tilt the tool
arm leftward to the stop (45°) by the handle
1.
Checking: (see figure R1)
– Adjust an angle gauge to 45° and position it
on the saw table 15.
The leg of the angle gauge must be flush with
the saw blade 5 over the complete length.
Adjusting: (see figure R2)
– Loosen the lock nut of stop screw 24 with
the provided ring spanner 35 (13 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 32 again.
– Afterwards, retighten the lock nut of the stop
screw 24 again.
In case the angle indicator 47 is not in a line with
the 45° mark of the scale 51, firstly check the 0°
setting for the bevel angle and the angle indica-
tor again. Then repeat the adjustment of the 45°
bevel angle.
OBJ_BUCH-1040-001.book Page 43 Monday, January 18, 2010 12:35 PM
To Next Page
Loading...
