44 | English
1 609 929 T11 | (18.1.10) Bosch Power Tools
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table 15 to the 0° detent 14.
The lever 13 must be felt to engage in the de-
tent.
Checking: (see figure S1)
– Adjust an angle gauge to 90° and position it
between the fence 6 and the saw blade 5 on
the saw table 15.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure S2)
– Loosen all Allen screws 34 with the Allen key
21 provided.
– Turn the fence 6 until the angle gauge is flush
over the complete length.
– Retighten the screws again.
Transport
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion.
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Carry the machine by the transport handle 29
or hold it by the recessed grips 18 on the
sides of the saw table.
f The power tool should always be carried by
two persons in order to avoid back injuries.
f When transporting the power tool, use only
the transport devices and never use the
protective devices.
Maintenance and Service
Maintenance and Cleaning
f Before any work on the machine itself, pull
the mains plug.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
Cleaning
For safe and proper working, always keep the
power tool and its ventilation slots clean.
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean.
Remove dust and chips after each working pro-
cedure by blowing out with compressed air or
with a brush.
Clean the roller 26 regularly.
Accessories
Quick-action clamp . . . . . . . . . . 2 608 040 205
Insert plate. . . . . . . . . . . . . . . . . 2 607 960 015
Dust bag. . . . . . . . . . . . . . . . . . . 2 605 411 204
Angle adapter
for dust bag . . . . . . . . . . . . . . . . 2 600 499 070
Extension bars . . . . . . . . . . . . . . 2 607 001 911
Saw blades for wood and plate materials, pan-
els and strips/mouldings
Saw blade 305 x 30 mm,
40 teeth . . . . . . . . . . . . . . . . . . . 2 608 640 440
OBJ_BUCH-1040-001.book Page 44 Monday, January 18, 2010 12:35 PM
To Next Page
Loading...
