Bosch PXY8 HC Series - 14 PanBoost; 14.1 Recommended applications; 14.2 Switching on PanBoost; 14.3 Switching off PanBoost

PanBoost en
13
Note:In certain circumstances, the appliance switches
this function off to protect the electronic elements in-
side the hob.
PanBoost
14 PanBoost
1
You can use this function to heat up pans more quickly
than with . Do not use the PowerBoost function with
frying pans – this may damage the coating.
You can activate the function via Home Connect or Fa-
vourite button.
This function is available for all cooking zones,
provided the other cooking zone on the same side is
not in use. Otherwise, ⁠and flash on the display for
the selected cooking zone. then switches on auto-
matically.
14.1 Recommended applications
¡ Do not place a lid on the pan.
¡ Never leave pans unattended when they are heating
up.
¡ Only use cold pans.
¡ Use pans with a completely flat base. Do not use
pans with a thin base.
14.2 Switching on PanBoost
Requirement:Assign the function to .
→"Favourite button", Page10.
1.
Select the cooking zone.
2.
Touch ⁠.
a lights up.
a The function is activated.
Note:You can also switch on this function when cook-
ing with a connected FlexZone.
14.3 Switching off PanBoost
1.
Select the cooking zone.
2.
Select the power level.
a goes out
a The function is switched off.
Note:To avoid high temperatures, this function auto-
matically switches itself off after 30 seconds.
Keep-warm function
15 Keep-warm function
1
You can use this function to melt chocolate or butter,
and to keep meals warm.
You can activate the function via Home Connect or Fa-
vourite button.
15.1 Switching on Keep-warm function
Requirement:Assign the function to .
→"Favourite button", Page10.
1.
Select the required cooking zone.
2.
Touch ⁠.
lights up.
a The function is switched on.
15.2 Switching off Keep-warm function
1.
Select the cooking zone.
2.
Set to
goes out.
a The function is switched off.
Transfer settings
16 Transfer settings
You can use this function to transfer the power level
and the programmed cooking time from one cooking
zone to another.
16.1 Transfer settings
Requirement:Move the cookware to a cooking zone
which is not switched on, which you have not yet pre-
set or on which no other cookware has been previously
placed.
1.
Move the cookware.
a The cookware is detected.
a The previously selected power level and flash al-
ternately on the display for the new cooking zone.
1
Available depending on software version. Further information on availability can be found on the website.