6/68 About this documentation
Bosch Rexroth AG, A4CSG, Series 3x, RE 92105-01-B/06.2017
1.3 Representation of information
Standardized safety instructions, symbols, terms and abbreviations are used
throughout this documentation so that you can work quickly and safely with your
product. To give you a better understanding they are explained in the sections below.
1.3.1 Safety instructions
This documentation includes safety instructions in chapter 2.6 “Product-specific
safety instructions” on page 11 and in chapter 3 “Alphabetical index” on
page15 and before a sequence of actions or an instruction for action involving a
risk of personal injury or damage to equipment. The described danger prevention
measures must be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Type and source of danger!
Consequences of noncompliance
▶ Measures to prevent danger
▶ <List>
• Warning sign: draws attention to the danger
• Signal word: identifies the degree of the danger
• Type and source of danger: indicates the type and source of the danger
• Consequences: describes what occurs if the safety instructions are not complied
with
• Precautions: states how the danger can be avoided
Table 2: Hazard classes as defined in ANSI Z535.6-2006
Warning sign, signal word Meaning
DANGER
Identifies a dangerous situation that will result in death or
serious injuries if it is not avoided.
WARNING
Identifies a dangerous situation that may result in death or
serious injuries if it is not avoided.
CAUTION
Identifies a dangerous situation that may result in minor to
moderate injuries if it is not avoided.
NOTICE
Property damage: The product or the environment may get
damaged.
To Next Page
Loading...
