Bosch Rexroth A2FM series - Location of working line ports on port plates

RE 91001-01-X-B2/01.2016, Bosch Rexroth AG
Axial piston fixed motor | A2FM for explosive areas
Dimensions, sizes 10, 12, 16
11
Dimensions [mm]
▼ Location of working line ports on port plates
030 – threaded connections A and B on side, opposite 040 – threaded connections A and B on side and at rear
AB
Y
91
56
131
166 85
AB
Y
91
56
131
166
85
95
34
147
69
Plate Ports Standard
3)
Size
1)
p
maxabs
[bar]
2)
State
4)
030 A, B Working port DIN 3852 M22 × 1.5; 14 deep 450 O
040 A, B Working port DIN 3852 M22 × 1.5; 14 deep 450 each 1 × O
1) For notes on tightening torques, see the instruction manual.
2) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
3) The spot face can be deeper than as specified in the standard
4) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)