Bosch Rexroth A2FM series - Dimensions sizes 56, 63; Shaft options; Ports

Bosch Rexroth AG, RE 91001-01-X-B2/01.2016
16 A2FM for explosive areas | Axial piston fixed motor
Dimensions sizes 56, 63
Dimensions [mm]
Dimensions sizes 56, 63
T
1
T
2
A B
20
32
1)
10
ø125
–0.025
40°
117
70
45°
45°
150
150
13.5
160
30
50
31
ø128
Flange
ISO3019‑2
▼ Splined shaft DIN 5480,
NG56, 63
▼ Splined shaft DIN 5480,
NG56
▼ Parallel keyed shaft, DIN 6885,
NG56, 63
▼ Parallel keyed shaft, DIN 6885,
NG56
Z ‑ W35×2×16×9g
Z – W30×2×14×9g B – AS10×8×50 P – AS8×7×50
40
32
M12 × 1.75
2)3)
⌀40
9.5
28
35
27
M12 × 1.75
2)3)
⌀40
9.5
28
38
60
M12 × 1.75
2)3)
⌀40
⌀35
+0.018 +0.002
9.5
28
Key width 10
33
60
M12 × 1.75
2)3)
⌀40
⌀30
+0.015 +0.002
9.5
28
Key width 8
Ports Standard Size
3)
p
maxabs
[bar]
4)
State
7)
A, B Working port (see subplates, page 17) 450
T
1
Drain port DIN 3852
6)
M18 × 1.5; 12 deep 3 X
5)
T
2
Drain port DIN 3852
6)
M18 × 1.5; 12 deep 3 O
5)
1) To shaft collar
2) Center bore according to DIN332 (thread according to DIN13)
3) For notes on tightening torques, see the instruction manual.
4) Depending on the application, momentary pressure peaks may occur.
Keep this in mind when selecting measuring devices and fittings.
5) Depending on installation position, T
1
or T
2
must be connected
(see also installation instructions on page 27).
6) The spot face can be deeper than as specified in the standard
7) O= Must be connected (plugged on delivery)
X= Plugged (in normal operation)